ΔP CONTROL FLOW LOOP / FIELD RATE
Gongyi Xinqi Polymer Co., Ltd.Polyacrylamide Friction ReducerPRESSURE RESPONSE DESKSEND WATER & RATE →
Product specification

Friction Reducer Dosage Units: GPT, ppm and Active-Polymer Cost

Convert friction-reducer product volume to active-polymer concentration with explicit gallon units, density and activity, without treating examples as dosage advice.

WATER
actual analysis
FLOW
matched condition
ΔP
complete trace
Metering pumps and additive dosing equipment beside a hydraulic fracturing blender
PURCHASING / WATER AND PRESSURE

Published · Updated · Gongyi Xinqi Polymer Co., Ltd.

SHEET INDEX01Write out every dosage denominator02Convert volume ratios before applying activity03Use a transparent illustrative calculation04Keep the test and pump record consistent05Connect unit conversion to commercial comparison06Ask for a quotation with unambiguous units
01

Write out every dosage denominator

GPT commonly means gallons of supplied product per thousand gallons of base fluid, but the buyer must confirm the convention used in the quotation and job record. State US or Imperial gallons and whether the base-fluid volume or total mixture is the denominator. Do not carry an unexplained abbreviation into a contract or laboratory comparison.

A product-volume ratio alone does not state polymer concentration. Dry feed, stock-solution feed and supplied emulsion volumes require different calculation paths. Follow the active-content specification before converting between product and polymer quantities.

02

Convert volume ratios before applying activity

At a product ratio of one litre per thousand litres of base water, the numerical product volume ratio is the same as one gallon per thousand gallons when the same gallon unit is used in numerator and denominator. This is a ratio equivalence, not a recommendation that any particular ratio is suitable for the job.

To estimate polymer mass added per litre of base fluid, multiply the product volume ratio by formulation density and polymer mass fraction using consistent units. Do not multiply by total solids when the intended result is active polymer, and do not substitute density from an unrelated product.

03

Use a transparent illustrative calculation

For arithmetic illustration only, assume 1 US gallon of product per 1,000 US gallons of base water, product density 1.00 kilogram per litre and active-polymer mass fraction 0.30. The addition is 0.30 kilogram of polymer per cubic metre of base water, or 300 milligrams per litre on that base-volume basis.

These assumed values are neither a Xinqi specification nor a field dose. Exact mixture-based concentration uses the final fluid volume or mass as appropriate. A ppm mass fraction means milligrams per kilogram; equating it with milligrams per litre requires an explicit fluid-density assumption.

04

Keep the test and pump record consistent

Record whether a loop dose was calculated from neat product, a prepared stock or a diluted feed. Verify stock concentration, preparation losses and metering calibration. A nominal injection setting can disagree with delivered polymer mass if density, feed concentration or pump output is wrong.

Use actual collection or calibration data where safe and appropriate under the operator's procedure. Include time, temperature and product identity with the conversion. The flow-loop protocol should retain both raw metering quantities and the derived active addition.

05

Connect unit conversion to commercial comparison

If price is per kilogram of product, multiply verified product consumption per water volume by that delivered price. If price is per litre, use the corresponding verified volume consumption. Activity normalization is useful for comparison, but the approved performance dose determines the product actually purchased.

Do not convert a high pressure-reduction number into an arbitrary dose saving. Compare candidates at the same accepted response window and hydraulic duty. Include mixing, dilution and handling requirements if one candidate needs a different preparation route.

06

Ask for a quotation with unambiguous units

Provide base-water volume or rate, product form, metering arrangement, density basis, active definition and the desired quotation unit. Ask the supplier to show conversions where their recommended screening quantities use a different unit system. Confirm the understanding before trial material is ordered.

Send those details through the dose and quotation enquiry. The calculations support consistent testing and purchasing; the operator's qualified team must establish safe operating doses and pressure limits using representative tests and field controls.

WhatsAppEmail