ΔP CONTROL FLOW LOOP / FIELD RATE
Gongyi Xinqi Polymer Co., Ltd.Polyacrylamide Friction ReducerPRESSURE RESPONSE DESKSEND WATER & RATE →
Trial and delivery control

Friction Reducer Field Trial Acceptance Before a Bulk Order

Define a friction-reducer trial with stable-rate comparisons, calibrated consumption, full pressure records, stop conditions and documented purchasing release.

WATER
actual analysis
FLOW
matched condition
ΔP
complete trace
High-pressure surface piping and pumping equipment at a hydraulic fracturing site
PURCHASING / WATER AND PRESSURE

Published · Updated · Gongyi Xinqi Polymer Co., Ltd.

SHEET INDEX01Agree the trial question before ordering material02Calculate a practical trial quantity03Preserve a meaningful baseline04Verify delivered product consumption05Set pass, conditional pass and stop rules06Release purchasing with the evidence attached
01

Agree the trial question before ordering material

A purchasing trial should answer whether a named candidate can meet the required hydraulic response within the intended water and equipment envelope. State the incumbent, water sources, rate range and operational constraints. Do not set a universal pressure-reduction target without explaining the baseline and measurement location.

The high-rate pumping review helps distinguish friction effects from total system pressure. The operator must own the safe trial procedure, pressure limits and decisions to stop or modify operations.

02

Calculate a practical trial quantity

Estimate product needs from planned water volume, an approved bounded screening range and the trial schedule. Allow for commissioning and controlled repeats where justified. Separate this forecast from a dosage recommendation and keep it distinct from the eventual monthly supply requirement.

Confirm packaging, unloading, metering and stock segregation before the trial order. A trial becomes difficult to interpret if the candidate cannot be kept separate from incumbent material or if the actual feed volume cannot be measured consistently.

03

Preserve a meaningful baseline

Record water, flow, equipment configuration and additive program during the reference period. Select stable comparison intervals under the operator's procedure rather than compare unrelated moments from a changing job. Time-align chemical feed, water blend, pressure and rate data.

The loop-test controls can inform the evidence plan, but a field system introduces additional variables. State where comparability is incomplete rather than describing an uncontrolled pressure drop as proven polymer performance.

04

Verify delivered product consumption

Check feed calibration, product identity, density or mass basis and any dilution. Capture start and finish inventory as appropriate to the metering system. A nominal pump setting is not sufficient evidence of actual consumption, especially if viscosity, suction or air entrainment changes.

Record hydration or inversion conditions and the equipment path. If field performance differs from the laboratory, investigate preparation and mechanical exposure before attributing the difference to a defective product. Preserve the original sample and received-lot identities for comparison.

05

Set pass, conditional pass and stop rules

Define pressure response, response time, operational stability and relevant compatibility observations before the run. Identify who may stop a trial and what evidence requires investigation. The rules should respect the operator's safety and well-design authority, not encourage continued pumping to complete a supplier comparison.

Conditional acceptance should specify the remaining limitation, such as a blend boundary, feed arrangement or pending repeat. Keep unplanned water or rate changes in the report. Do not remove difficult intervals simply to produce a favourable average.

06

Release purchasing with the evidence attached

The final trial record should include product code, lot, actual consumption, water envelope, aligned traces, deviations, cost calculation and technical approval. State whether the release covers the tested condition only or a wider range supported by evidence. A successful trial does not create a guarantee for every future job.

Send the intended trial volume, schedule and data requirements through the trial-order enquiry. Use the bulk-contract checklist only after the team can connect technical acceptance to an identifiable repeat-supply material.

WhatsAppEmail